Valor Fires 842 Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Ohřívače prostoru Valor Fires 842. Model 842 - PlumbNation Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 25
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
5132650 / 01
© Baxi Heating U.K. Limited 2008.
Model 842
ELECTRIC HEATER
Fitted with a Nanofascia.
(GC No. EF-032-32)
Important: Please keep your guide in a safe place for future reference.
INSTALLER AND OWNER GUIDE
This guide is intended to help you
install and care for your Valor Fires
electric heater. Please read carefully
before installing and using your
heater. However, if further
information is required, our
Valor Fires Technical Helpline will
be pleased to help.
Telephone 0844 8711 565 (National
call rates apply in the United
Kingdom).
In the Republic of Ireland
Telephone 0044 844 8711 565.
Zobrazit stránku 0
1 2 3 4 5 6 ... 24 25

Shrnutí obsahu

Strany 1 - Nanofascia

5132650 / 01© Baxi Heating U.K. Limited 2008.Model 842ELECTRIC HEATERFitted with a Nanofascia.(GC No. EF-032-32)Important: Please keep your guide in a

Strany 2 - 0844 800 3460

heater it is important to check that the lamphas not become loose in transit. The lamp islocated into a cradle on the rear of the accesspanel. Open th

Strany 3

Securing the heater.The contents have been identified in figure 4 (Fascias are not included).Page 10INSTALLER AND OWNER GUIDE© Baxi Heating U.K. Limit

Strany 4

The heater must be secured into position to prevent it from being tipped over.The following securing options are available: Method A - Securing the h

Strany 5

Method B - Securing with wire.This method of securing is recommended where the wall / brickwork is in poorcondition or where marble back panels / surr

Strany 6

small hole on the left hand side of the heater (See figure 7). 11. Locate the heater in the fireplace opening, then from the front of the heater, gent

Strany 7

Method D - Securing with the optional spacer frame supplied in kit0584081.The optional spacer is for use where a flat wallinstallation is required. 1.

Strany 8

Method E - Wall mounting with the optional spacer frame kit (0584081)and Elevated Installation kit supplied in kit (0584091).The Optional Spacer Frame

Strany 9

Fitting the brackets to the heater.1. Secure the spacer frames to the heater as in steps 1 and 7 of METHOD D (Seefigure 10).2. The Elevated Installati

Strany 10 - INSTALLER AND OWNER GUIDE

5. FITTING THE FASCIAImportant: Before fitting the fascia ensure that you have completed theinformation on the last page of this guide.Fitting the fas

Strany 11

7. CLEANING AND MAINTAINING THE HEATERImportant Safety.Before undertaking maintenance or replacing the lamp always disconnect the heaterfrom the elect

Strany 12

the nation’s favourite forPLUMBING & HEATING SUPPLIESSECURE PAYMENTSshop online with confidenceFREE SHIPPINGon all orders over £100 to mainland UK

Strany 13

 Replace the lamp and close the accesspanel. When handling the lamp avoidtouching the glass with bare fingers asthis will reduce the life of the lamp

Strany 14

For spares inquiriesSpare parts are available nationwide via the ‘interpart stockist network’. For yourlocal stockist consult Yellow pages under ‘Cent

Strany 15

9. WARRANTY AND SERVICEInformation for the customerStandard Warranty Terms & ConditionsThe warranty is for 12 months subject to contract.In the Un

Strany 16

What this warranty does not coverRepairs to heaters which haven’t been installed properly and as set out in this guide.Faults caused by inadequate sup

Strany 17

To be completed by the customer:Page 23INSTALLER AND OWNER GUIDE© Baxi Heating U.K. Limited 2008.Brand (Please tick)Baxi Valor Wonderfire Other...

Strany 18

© Baxi Heating U.K. Limited 2008.

Strany 19

© Baxi Heating U.K. Limited 2008.All rights reserved. No part of this publication may be reproduced in any material form(including photocopying), stor

Strany 20

Safety First.Valor Fires heaters are CE Approved and designed to meet the appropriate BritishStandards and Safety Marks.Quality and Excellence.All Val

Strany 21

1. HANDLING AND UNPACKINGBefore continuing any further with the installation of this heater please read thefollowing:Important instructions. A carry

Strany 22

Always Always install the heater in accordance with this guide. If in doubt obtain expert advice. Always make sure the electrical socket is accessib

Strany 23

3. OPTIONAL KITSThe following kits are obtainable either from your heater supplier or direct from ValorFires Sales.Spacer frame kit 0584081Elevated in

Strany 24

4. FITTING THE HEATERBefore continuing any further with the installion of the heater please fill in thedetails on the last page of this guide.Importan

Strany 25

Q Do you want to fit the heater against a flat wall with the base of the heater ona hearth or similar surface?A You will need to purchase the optional

Komentáře k této Příručce

Žádné komentáře